Microsquad JB.Fpv Edition – F4 Brushless 2-3S with built-in Receiver (DIY BUILD KIT)

Microsquad JB.Fpv Edition – F4 Brushless 2-3S with built-in Receiver (DIY BUILD KIT)

If you want a brute racing / freestyle whoop that flies extremely well and is equipped with the latest hardware, then you are in the right place with the Microsquad JB.Fpv Edition! Together with the Microsquad 1102 (9000kv) engines, latest Microsquad JB.Fpv 40mm Props and Crazybee F4 V2 1-3s FC you will get an amazing rocket that will blow you away!

Specs

• Flightcontroller: CRAZYBEE F4 PRO Firmware target: CrazybeeF4
• MCU: STM32F411CEU6 (100MHZ, 512K FLASH)
• Sensor: MPU-6000 (SPI connection)
• Board size: 28.5 * 28.5MM
• Power supply: 1-3S battery input (DC 3.5-13V)
• Built-in 5A (each) Blheli_S 4in1 ESC Dshot600 ready
• Built-in SPI Frsky, FlySky, DSM2 / DSMX receiver with telemetry
• Built-in Betaflight OSD (SPI Control)
• Built-in Current meter Max 28A
• Current meter scale set to 1175
• Built-in 5V 1A Buck / Boost with LC filter
• Built-in voltage detection
• BLHELI_S pass-through Ready
• Multi Serial port support
• Heading LED Ready
• Weight: ca. 4,3g

ESC
• MCU upgraded to EFM8BB21
• Power supply: 1-3S LiPo / LiPo HV (3.5v / 13v)
• Current: 5A continuous peak 6A (3 seconds)
• Support BLHeliSuite programmable
• Factory firmware: S_H_50_REV16_7.Hex
• Default protocol: Dshot150 / Dshot300 / Dshot600 / Oneshot125 / Multishot / PWM
• Motor plug: JST PH1.25 3-pole

Receiver
• SPI BUS receiver
• Compatible FrSky, FlySky, DSM2 / DSMX
• Channels: 8ch / 16ch (depends on protocol)
• Failsafe support
• No ground interference ( Transmitting and receiving 1 m from the ground): 300m
• *external receiver can also be connected!

Caddx EOS2 Kamera (custom)
• ready with Molex plug for easy VTx plug ’n play
• Input Voltage: 3.3V – 6V
• Camera Resolution: 1200TVL
• Camera Sensor: 1/3 “ CMOS
• Lense: 2.1mm, FOV 160 °
• D-WDR, 2 DNR, 0.001Lux @ F1.2
• Rolling Shutter
• Latency: ca. 3ms
• Video Format: PAL 4:3
• Power: 25mw 300 ~ 350mA bei 5V DCIN
• Size: 14 x 14 x 16.0mm
• Weight: 5g

VTx with 25/200mW* and 40 Kanal (incl. Raceband)
• Input Voltage: 3.3V – 5.5V
• Stromaufnahme: 300mA
• Frequency: 5,8GHz 5 Band 40 Kanal inkl. Raceband
• UFL Antenna
• SmartAudio support
• Weight: ca. 2g (without Antenna)

Motors
• SCHUBKRAFT 1102 KV9000
• Shaft: 1mm
• Motor mounting: M1.4 on Dia 6.6mm
• Plugs: Micro JST-1.25 3-pin
• Weight: ca 2.9g
• longer Cable: 5cm (without plug)
• Color: red/black

Props
• Microsquad JB.Fpv 40mm Vierblatt 1.0 – clear blue

Weight (without LiPo) : ca. 36g

Included
• 1 x Microsquad JB.Fpv Edition – mit built-in Receiver (DIY BUILD KIT)
• 1 x USB Charger
• 1 x Screwdriver and Proptool

Required:
• Transmitter
• The delivery does NOT contain Lipo! We recommend lightweight Microsquad or GNB 2S 300-520mAh Lipo with a high C rate

* Attention
The video transmitter may spark on non-harmonized frequencies which may not be used in Germany and the EU. § 55 of the Telecommunications Act (TKG) prescribes the following frequencies for use: 5725 to 5875 MHz. The device may only be operated in this frequency range with a power of 25mW. The use of unauthorized frequencies and higher performance constitutes a misdemeanor. In the delivery state the device is in DE and EU allowed 5740 MHz (band F, channel 1) with a power of 25mW.