CrazyBee Pro F4 v2 Brushless Flightcontroller 1-3s with built-in Receiver

CrazyBee Pro F4 v2 Brushless Flightcontroller 1-3s with built-in Receiver

New
• 3s Lipo support!
• bigger Boot / Bind Button
• BAT/GND Lipocable imporved (through hole soldering)

Specs
• Flightcontroller: CRAZYBEE F4 PRO FR Firmware target: CrazybeeF4
• MCU: STM32F411CEU6 (100MHZ, 512K FLASH)
• Sensor: MPU-6000 (SPI connection)
• Board size: 28.5 * 28.5MM
• Power supply: 1-3S battery input (DC 3.5-13V)
• Built-in 5A (each) Blheli_S 4in1 ESC Dshot600 ready
• Built-in SPI Frsky, FlySky, DSM2 / DSMX receiver with telemetry
• Built-in Betaflight OSD (SPI Control)
• Built-in Current meter Max 28A
• Current meter scale set to 1175
• Built-in 5V 1A Buck / Boost with LC filter
• Built-in voltage detection
• BLHELI_S pass-through Ready
• Multi Serial port support
• Heading LED Ready
• Weight: ca. 4,3g

ESC
• MCU upgraded to EFM8BB21
• Power supply: 1-3S LiPo / LiPo HV (3.5v / 13v)
• Current: 5A continuous peak 6A (3 seconds)
• Support BLHeliSuite programmable
• Factory firmware: S_H_50_REV16_7.Hex
• Default protocol: Dshot150 / Dshot300 / Dshot600 / Oneshot125 / Multishot / PWM
• Motor plug: JST PH1.25 3-pole

Receiver
• SPI BUS receiver
• Compatible FrSky, FlySky, DSM2 / DSMX
• Channels: 8ch / 16ch (depends on protocol)
• Failsafe support
• No ground interference ( Transmitting and receiving 1 m from the ground): 300m
• *external receiver can also be connected!

Included
• 1 x CrazyBee Pro F4 v2 Brushless Flightcontroller 1-3s with built-in Receiver
• 1 x Screws/Softmount and powercables