CrazyBee Pro F3 Brushless Flightcontroller 1-2s with built-in Receiver
45,95 €
keine Ausweisung der Mehrwertsteuer gemäß § 19 UStG + Versandkosten
1-2s Brushless ! with built-in receiver?
No problem!
CrazyBee Pro F3 Brushless Flightcontroller 1-2s with built-in Receiver
Specs:
• Firmware: Betaflight_3.3.0_Crazybee Pro
• Betaflight target: CRAZYBEE3 Pro
• MCU: STM32F303CCT6 (72MHZ, 256K FLASH)
• Sensor: MPU-6000(SPI connection)
• Power supply: 1-2S battery input (DC 3.5-8.7V)
• Built-in 5A (each) Blheli_S 4in1 ESC Dshot600 ready
• Built-in Frsky, FlySky or DSM2 / DSMX receiver with telemetry D8
• Built-in Betaflight OSD (SPI Control)
• Built-in Current meter (Max 28A)
• Built-in 5V 1A Buck / BoostBEC with LC filter
• Built-in voltage detection
• BLHELI_S pass-through Ready
• Heading LED
• size: 29 x 29mm
• weight: 3.5g
ESC:
• Power supply: 1-2S LiPo/LiPo HV
• Current: 5A continuous peak 6A (3 seconds)
• Supports BLHeliSuite programming
• Factory firmware: S_H_50_REV16_7.HEX
• Motor connector: JST PH1.25 3pin
• Signal Support: Dshot150 / Dshot300 / Dshot600 / Oneshot125 / Multishot / PWM
Receiver:
• SPI BUS receiver
• Compatible Frsky, FlySky or DSM2 / DSMX
• Channels: 8-16ch (depends on selected protocol)
• Failsafe support
• No ground interference ( Transmitting and receiving 1 m from the ground): 300m
• *external receiver can also be connected!
Included
• 1 x CrazyBee Pro F3 Brushless Flightcontroller 1-2s with built-in Receiver
• 1 x Screws/Softmount and powercables
| Weight | 0.1 kg |
|---|---|
| Dimensions | 5 × 2 × 1 cm |
| Build-In Empfänger | FrSky, FlySky, DSM2 / DSMX |
Be the first to review “CrazyBee Pro F3 Brushless Flightcontroller 1-2s with built-in Receiver”
You must be logged in to post a review.
Reviews
There are no reviews yet.