CrazyBee F3 Brushless Flightcontroller with built-in Receiver

CrazyBee F3 Brushless Flightcontroller with built-in Receiver

Specs:
• Firmware: Betaflight_3.3.0_Crazybee
• Betaflight target: CRAZYBEEF3
• MCU: STM32F303CCT6 (72MHZ, 256K FLASH)
• Sensor: MPU-6000(SPI connection)
• Power supply: 1S battery input (DC 3.5-4.35V)
• Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
• Built-in FrSky, FlySky or DSM2 / DSMX receiver
• Built-in Betaflight OSD(SPI Controll)
• Built-in Current meter (Max 14A,could be modified to 28A by replace resistor)
• Built-in 5V 0.8A BEC with LC filter
• Built-in voltage detection
• BLHELI_S pass-through Ready
• Heading LED
• size: 29 x 29mm
• weight: 3.5g

ESC:
• Power supply: 1S LiPo/LiPo HV (4.2v/4.35v)
• Current: 5A continuous peak 8A (3 seconds)
• Supports BLHeliSuite programming
• Factory firmware: O_L_5_REV16_6.HEX
• Motor connector: JST PH1.25 3pin
• Signal Support: Dshot150/Dshot300/Dshot600/Oneshot125/Multishot/PWM

Receiver:
• SPI BUS receiver
• Compatible FrSky, FlySky or DSM2 / DSMX receiver
• Channels: 8-16ch (depends on selected protocol)
• Failsafe support
• No ground interference ( Transmitting and receiving 1 m from the ground): 300m
• *external receiver can also be connected!

Included
• 1 x CrazyBee F3 Brushless Flightcontroller with built-in Receiver
• 1 x Screws/Softmount and powercables