Microsquad 65mm Pro Brushless RACE with built-in Receiver (DIY BUILD KIT)

Microsquad 65mm Pro Brushless RACE with built-in Receiver (DIY BUILD KIT)

Specs
• Flightcontroller: CrazyBee F3 with built-in Receiver
• Betaflight target: CRAZYBEEF3
• MCU: STM32F303CCT6 (72MHZ, 256K FLASH)
• Sensor: MPU-6000(SPI connection)
• Power supply: 1S battery input (DC 3.5-4.35V)
• Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
• Built-in FrSky, FlySky, DSM2 / DSMX receiver with telemetry
• Built-in Betaflight OSD(SPI Controll)
• Built-in Current meter (Max 14A,could be modified to 28A by replace resistor)
• Built-in 5V 0.8A BEC with LC filter
• Built-in voltage detection
• BLHELI_S pass-through Ready
• Heading LED
• size: 29 x 29mm
• weight: 3.5g

ESC
• Power supply: 1S LiPo/LiPo HV (4.2v/4.35v)
• Current: 5A continuous peak 8A (3 seconds)
• Supports BLHeliSuite programming
• Factory firmware: O_L_5_REV16_6.HEX
• Motor connector: JST PH1.25 3pin
• Signal Support: Dshot150/Dshot300/Dshot600/Oneshot125/Multishot/PWM

Receiver
• SPI BUS receiver
• Compatible FrSky, FlySky, DSM2 / DSMX Empfänger
• Channels: 8ch
• Failsafe support
• No ground interference ( Transmitting and receiving 1 m from the ground): 300m
• *external receiver can also be connected!

Canopy with Camera/VTx:
• Input Voltage: 3.3V – 5.5V
• Camera Resolution: 800TVL
• Field of View: 150°
• Video Format: NTSC
• Power: 25mw
• Weight: 4,45g
• super easy switching between channels!

Motors
• SCHUBKRAFT Microsquad 0603 20000kV

Props
• Microsquad 31mm 4blade – orange

Weight (without LiPo) : 20,75g

Included
• 1 x SCHUBKRAFT Microsquad 65mm Pro Brushless RACE (DIY BUILD KIT)
• 1 x USB Charger
• 1 x Screwdriver and Proptool
• 1 x SCHUBKRAFT decal sheet (High-Tech with transfer sheet)

Required:
• Transmitter
• The delivery does NOT contain Lipo! We recommend lightweight Microsquad 1S 300mAh HV Lipo with a high C rate