Diamond F4 AIO 5in1 1s build-in RX + VTX Flight Controller
This flight controller is inspired from Pilot „Angry Don FPV“. Diamond F4 AIO 5-IN-1 Flight controller has a built-in Open VTX, ESC, OSD, and receiver – all on one triangle-shaped whoop board!
The 3 corners fit 25.5mm whoop mounting spacing.
Specs
• Flugcontroller: Diamond F4 Firmware target: CrazybeeF4
• Sensor: MPU-6000 or ICM20689 or BMI270(SPI connection)
• Spannungseingang: 1S input (DC 2.9-4.35V)
• Built-in 5A (each) Blheli_S 4in1 ESC Dshot600 ready
• Built-in 5.8G OPEN VTX
• Built-in SPI ELRS V2.0/ Frsky receiver
• Betaflight OSD (SPI Control)
• Built-in 5V 1A BEC
• weight: ca. 3,4g
ESC
• MCU upgraded to EFM8BB21
• Power supply: 1S LiPo/ LiPo HV
• Current: 5A continuous peak 6A (3 seconds)
• Support BLHeliSuite programmable
• Factory firmware: O_H_5_REV16_8.HEX
• Default protocol: DSHOT600
Empfänger
Onboard ELRS V2.0 receiver Version
• Packet Rate option: 50Hz/150Hz/250Hz/500Hz
• ExpressLRS Firmware version: V2.0
• RF Frequency: 2.4GHz
• Antenna : Enameled copper wire antenna
• Telemetry output Power: <12dBm
• Receiver protocol: SPI ExpressLRS
• Compatible with ExpressLRS V2.0 TX Module
• Couldn’t flash separately ExpressLRS firmware
Onboard Frsky SPI D8 receiver Version
• SPI BUS receiver Frsky D8 compatible
• Compatible Non EU transmitter D8 Channels: 8ch
• Failsafe support
• No ground interference (Transmitter and receiver 1 m from the ground): 200m~300m
Onboard Flysky SPI receiver Version
• SPI BUS receiver
• Protocol: AFHDS and AFHDS-2A Switchable
• Channels: 8ch (AFHDS) or 14ch (AFHDS-2A)
• No ground interference (Transmitter and receiver 1 m from the ground): 200~300m
• Failsafe support
Onboard 5.8g Open VTX
• Firmware version: OPENVTX
• Smartaudio v2.1
• PIT Mode support
• RCE Mode support
• Channels:48ch
• Transmitting Power: 0/RCE/25mw/100mw/400mw
• Power supply: DC 5V
• Current (5v): <650ma (400mw)
Included
1x DiamondF4 AIO 5in1 Flight Controller
2x Connecting Wire
4x Damping Balls
4x Screws
Reviews
There are no reviews yet.