Happymodel BNF Larva-X HD 2.5-3″ 2in1 Toothpick / Whoop Quad – FrSky EU LBT Version

Happymodel BNF Larva-X HD 2.5-3″ 2in1 Toothpick / Whoop Quad – FrSky EU LBT Version

The Larva-X just got a convertible HD variant! This quad can be configured as a 2.5″ (65mm) whoop style build or up to 3″ toothpick setup. Choose the receiver that’s right for you. Check out the flight tests below!

Features
• Toothpick HD and Whoop HD 2 in 1 combo (Default Comes in Toothpick HD style)
• Toothpick style compatible both 2.5inch or 3inch propellers
• New design EX1203 High efficiency brushless motors
• Caddx baby Turtle provide 1080P 60FPS DVR video
• Camera Angle adjustable
• Full range receiver options
• Buzzer ready
• Smooth and powerful
• Compatible both for 2s-3s Lipo/LIHV
• Specifications
• Wheelbase: 125mm
• Size: 105mm*105mm*35mm(without propellers)
• Weight: Toothpick style ductless 63g (without battery)
• Whoopick style ducted 79g (without battery)

Motor
• Mode: EX1203 KV6200
• Configuration:9N12P
• Stator Diamter:12mm
• Stator Length:3mm
• Shaft Diameter:Φ1.5mm
• Motor Dimension(Dia.*Len):Φ15mm*15mm
• Weight(g):4.7g
• No.of Cells(Lipo):2S-3S

Flight Controller
• MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
• Sensor: MPU-6000(SPI connection)
• Board size: 28.5 * 28.5MM
• Power supply: 2-4S battery input (DC 7-17V)
• Built-in 10A(each) Blheli_S 4in1 ESC Dshot600 ready
• Could add external receiver on the FC board
• Built-in Betaflight OSD(SPI Control)
• Built-in Current meter Max 70A
• Current meter scale set to 470
• Built-in 5V 1A BEC
• Built-in voltage detection

Propellers
• Blades:2
• Material:PC
• Prop Disk Diameter:65mm
• Center Thickness:5mm
• Center Hole Inner diameter:1.5mm
• Max Prop Width:8mm
• Weight:0.3g
• Onboard 4in1

ESC
• MCU upgraded to EFM8BB21
• Power supply: 2-4S LiPo/LiPo HV (7v/17v)
• Current: 10A continuous peak 12A (5 seconds)
• Support BLHeliSuite programmable
• Factory firmware: F_H_40_REV16_7.HEX
• Default protocol: DSHOT600

VTX
• Output power: 25~200mw switchable
• Frequency: 40CH
• Input voltage: 3.3V 5.5V
• Current consumption: 300mA(type)
• Antenna: Micro UXII Antenna
• Frequency: 5.8GHz 5bands 40 channels
• With Race bandSmartaudio ready
• Weight: 3g

Caddx Baby Turtle
• TV system: NTSC/PAL changeable
• Video Resolution: 1080P@60fps / 1080P@30fps / 720@60fps
• Power Input: DC 4.5-20V
• Mini Illumination: 0.01lux
• Image Resolution: 2 Megapixels
• Working Current: 380mA@5V/160mA@12V (low consumption)
• OSD Menu: Yes (Support Voltage Display)
• Video Files: MP4
• Audio: Support
• Electronic Shutter : PAL : 1/50-100,000 NTSC : 1/60-100,100
• S/N Ratio: >60dB (AGC OFF)
• Video Output: CVBS
• Max Micro SD Card Supported: 8-64GB(need Class 10 or above, recommend Class 10/UHS-I/UHS-II)

Lipo Battery
• Capacity:450mAh
• Voltage:11.4v
• Continuous Discharge Rate: 75C
• Size: 66mmx21mmx18mm
• Weight: 42gConnector: XT30

Includes
• 1x Larva-X HD frame (with Toothpick style canopy and Whoop style canopy) – FrSky EU LBT
• 4x Whoop duct for Larva-X HD
• 4x EX1203 KV6200 Brushless Motors
• 1x Propeller Set
• 1x CADDX Baby Turtle
• 1x VTX 5.8g 25mw~200mw
• 2x 3S 11.1v 450mah 75c LiPo Battery
• 1x 5.8g Micro UXII antenna
• 1x Propeller disassemble tool